Just going out to check my bank balance, before going chemical shopping, for both the kinds of chemical goods that are to be ingested, and those which serve rather, as reagents for the creation of new artworks.
On the list:
Solvents: diethyl ether, THF, methylene chloride, benzene, carbon tet, carbon disulfide (bleerrgh! ick!), CBr4, acetone, DMF, and acetonitrile (methyl cyanide)
Reagents: HgCl2, nitromethane, nitroethane, phosphorus trichloride, PCl5, POCl3, sulfuryl ,chloride, thionyl chloride, piperidine, potassium cyanide (might go for the sodium salt, given that one gets more cyanide ion for the pound in one's pocket, courtesy of the lower atomic weight of Na compared to K), indole, benzothiophene, oxalyl chloride, LiAlH4, some borohydride, activated carbon, and formaldehyde so I can rustle up some plat cat and Pd/C. Have PdCl2 to work with but the platinum cat, that will be tricky, given the inertness of platinum. Means using some rather noxious chemicals to dissolve Pt metal, such as aqua regia, or nitrosyl chloride.
Ingestables-some N-cumyl-1-(5-fluoropentyl)indazole-3-carboxylate, conveniently now available as a 'C-liquid' for electronic cigarettes, dissolved in a mixture of propylene glycol and glycerine. Its a short acting cannabinoid (half hour, 25 minutes or so post intake, vaporised or smoked on inert carrier herbs in a bong, short lived, like the majority of these currently available indazole cannabinoidergic ligands, but its fucking potent, scarily so almost. I've had HU-210, a THC analog, but a full agonist at Cb1 receptors, and extremely, extremely long lived, known also for being one of the most potent cannabinoids so far known in terms of Ki and efficacy at Cb1 and Cb2Rs, that one is active at a dose of a couple of hundred micrograms, but this indazole bad boy, this one is the big bad motherfucking wolf at the door in terms of sheer weight potency, I don't even possess a scale capable of measuring individual single dose quantities of this, but dissolving a larger amount, accurately weighed, into a solvent base useable in my E-fag, at a 1mg/1ml concentration all that it takes is perhaps 3-4 modest inhalations, and it comes on with all the unstoppable momentum of a plush foam covered wrecking ball.
A place I'm evaluating for doing business also has an excellent selection of novel benzodiazepines, 3-fluorophenmetrazine, and 3-fluorinated analogs of both methyl- and ethylphenidate. Interestingly, seems like replacing hydrogen at the no.3 carbon of either of the ritalinic acid esters with a fluorine causes a dramatic increase in weight potency, active at 0.5-1mg from some reports.
The ethoxy analog of methoxphenidine, some methoxphenidine, diphenidine, deschloroketamine if I can find it, or bromoketamine.
http://researchchemist.co.uk/research-chemicals/special-offers is looking good, going to check the site out on safeorscam.com first though of course.
